SYTOS PLUS FOR OS/2 1.37
                     IBM THINKPAD 555MB
                       DRIVER DISKETTE

                        July 5, 1994

************************************************************

This Driver Diskette includes the following device driver:  
                 IBM THINKPAD 555MB

This Readme provides the following information:

1.1 Installing "IBM THINKPAD 555MB" Using Driver Disk
1.2 Installing SCSI Adapter Device Drivers under
    IBM OS/2 Version 2.x


1.1 INSTALLING "IBM THINKPAD 555MB" USING DRIVER DISK
    To install the device driver, follow these steps:
    1. "Select one of any backup device ..  from the Utilities".
    2. Insert this diskette into your diskette drive, and
       select [Driver Disk].
    3. In the "Load Device Drivers Diskette" window, enter
       the letter that represents your drive (A: is the
       default), and select [OK].
    4. At the "Select Backup Device Drivers" window, select
       the driver name and choose [OK].
    5. To add the device to the backup device list, select
       "Add new device" at the "Backup device setup..."
       window.
    6. Configure the backup device using instructions in the
       Sytos Plus User's Guide.

    Ensure that the SCSI adapter driver is installed as
    described in the following section.

1.2 INSTALLING SCSI ADAPTER DEVICE DRIVERS UNDER IBM OS/2
    VERSION 2.x
    Currently this release of Sytos Plus supports TMC-850IBM SCSI host
    adapters.  Future support will follow.  In order to run Sytos Plus with a 
    SCSI host adapter in the IBM OS/2 2.x environment, make sure the
    following two lines appear in your CONFIG.SYS file:

         BASEDEV=FD850IBM.ADD
         BASEDEV=OS2SCSI.DMD

    where FD850IBM.ADD corresponds to the SCSI Adapter
    Device Driver.
         NOTE:  FD850IBM.ADD should be on the option
         diskette that comes with your host adapter.
    If the lines are not in CONFIG.SYS, refer to your
    IBM OS/2 2.x documentation to add them.
         NOTE: Under version 2.0, you must have the
         OS/2 v2.0 Service Pack (Version XR06055),
         also known as the Corrective Service
         Facility, installed on your system to
         support backup devices that use SCSI host
         adapters.  If you do not have the OS/2 v2.0
         Service Pack installed, you will encounter
         problems running Sytos Plus under OS/2
         v2.0.  Contact your IBM representative to
         obtain the Service Pack.

    Reboot your system to let these changes take effect. 

         NOTE:  This file is being distributed with permission of Sytron Corporation.   

                   *** END OF README ***